|torque converter run out
|Page 1 of 1|
|Author:||candy69 [ December 29th, 2013, 12:07 am ]|
|Post subject:||torque converter run out|
any of my race buddies know how much run out is acceptable on the end of the pump snout on a torque converter?
|Author:||wakesupremo [ December 29th, 2013, 12:17 pm ]|
|Post subject:||Re: torque converter run out|
I would say as little as possible. I seem to remember mine moving in and out but not enough to measure without proper tools. I.E. couldn't measure with a tape measure but you could if you had a dial gauge set up properly.
|Page 1 of 1||All times are UTC [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group|